26+ Pertronix Distributor Wiring Diagram. Remove the distributor cap, and make sure that the rotor is pointing towards the first cylinder in the firing order. Remove the point wire, point, and condenser from the distributor.
Pull the grommet into place. This shows the proper hookup for a pertronix igniter in a car wired for negative ground, or earth if you prefer. Insert both wires through the hole in the distributor housing.
• Attach The Ignitor Ii Black Wire To The Negative Coil Terminal.
Pull the grommet into place. The wiring diagram shown below is modeled after one obtained from pertronix. Learn how to wire a pertronix distributor with this helpful wiring diagram.
Pull The Grommet Into Place.
Use needle nose pliers to grip the looped end of each spring. Insert both wires through the hole in the distributor housing. Therefore the point, condenser and hardware can be used as.
Feed The Two Terminal Ends Of The Wire Through The Hole In The Distributor Housing.
Disconnect all wires and hoses. Get detailed instructions on connecting the wires and installing the module, ensuring optimal. Find the wiring diagram for pertronix ignitor 2 for easy installation and troubleshooting.
Remove The Point Wire, Point, And Condenser From The Distributor.
Make sure that the wires do not interfere with any moving parts. The ignitor does not require any modification to the distributor. Use the cd box wiring instructions for point systems and treat the ignitor ii black wire as a point wire.
Detach Each Spring From The Inner And Outer Advance Pins.
Pull the grommet into place. Make sure that the distributor red and black wire are connected properly. Learn how to properly wire your ignition system and get your classic car or hot rod running smoothly.